Service Manual
Defaults Not congured
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the no-drop parameter. Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the monitor option.
6.5.10 Expanded to include the optional QoS order priority for the ACL entry.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. The following applies:
• The seq sequence-number command is applicable only in an ACL group.
• The order option works across ACL groups that are applied on an interface via the QoS policy
framework.
• The order option takes precedence over seq sequence-number.
• If you do not congure sequence-number, the rules with the same order value are ordered according
to their conguration order.
• If you congure sequence-number, the sequence-number is used as a tie breaker for rules with the
same order.
Related Commands
deny — congures a lter to drop packets.
permit — congures a lter to forward packets.
Extended IP ACL Commands
When an ACL is created without any rule and then applied to an interface, ACL behavior reects an implicit permit.
The following commands congure extended IP ACLs, which in addition to the IP address, also examine the packet’s protocol type.
The platform supports both Ingress and Egress IP ACLs.
204
Access Control Lists (ACL)