Service Manual

NOTE: When you congure ACL logging and byte counters simultaneously, byte counters may
display an incorrect value. Congure packet counters with logging instead.
Related Commands
permit — congures a MAC address lter to pass packets.
seq — congures a MAC address lter with a specied sequence number.
mac access-list standard
To congure a standard MAC ACL, name a new or existing MAC access control list (MAC ACL) and enter MAC ACCESS LIST mode.
Also refer to the Commands Common to all ACL Types section and the Common MAC Access List Commands section.
Syntax
mac access-list standard mac-list-name
To delete a MAC access list, use the no mac access-list standard mac-list-name command.
Parameters
mac-list-name Enter a text string as the name of the standard MAC access list (140 character
maximum).
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information
Dell Networking OS supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed specications about entries
allowed per ACL, refer to your line card documentation.
NOTE: Ingress ACLs are supported on C-Series and S-Series platforms only.
Access Control Lists (ACL)
229