Service Manual

AS_SET includes AS_PATH and community information from the routes included in
the aggregated route.
attribute-map map-
name
(OPTIONAL) Enter the keywords attribute-map then the name of a
congured route map to modify attributes of the aggregate, excluding AS_PATH
and NEXT_HOP attributes.
summary-only (OPTIONAL) Enter the keyword summary-only to advertise only the aggregate
address. Specic routes are not advertised.
suppress-map map-
name
(OPTIONAL) Enter the keywords suppress-map then the name of a congured
route map to identify which more-specic routes in the aggregate are suppressed.
Defaults Not congured.
Command Modes
• ROUTER BGP ADDRESS FAMILY
• ROUTER BGP ADDRESS FAMILY IPv6
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
At least one of the routes included in the aggregate address must be in the BGP routing table for the
congured aggregate to become active.
If routes within the aggregate are constantly changing, do not add the as-set parameter to the aggregate
as the aggregate aps to keep track of the changes in the AS_PATH.
In route maps used in the suppress-map parameter, routes meeting the deny clause are not suppress; in
other words, they are allowed. The opposite is also true: routes meeting the permit clause are suppressed.
If the route is injected via the network command, that route still appears in the routing table if the
summary-only parameter is congured in the aggregate-address command.
The summary-only parameter suppresses all advertisements. If you want to suppress advertisements to
only specic neighbors, use the neighbor distribute-list command.
In the show ip bgp command, aggregates contain an ‘a’ in the rst column and routes suppressed by the
aggregate contain an ‘s’ in the rst column.
Border Gateway Protocol
337