Service Manual
When an aggregate address is denied using a peer's outbound route-map, individual routes suppressed by
the aggregate address are advertised to that peer.
The attribute-map corresponding to an aggregate address is applied during the outbound update creation
time; hence the value set in that attribute-map will not be shown in the output of the show ip bgp
aggregate route command.
bgp add-path
Allow the advertisement of multiple paths for the same address prex without the new paths replacing any previous ones.
Syntax
bgp add-path [send | receive | both] path-count
Parameters
send Enter the keyword send to indicate that the system sends multiple paths to peers.
receive Enter the keyword receive to indicate that the system accepts multiple paths
from peers.
both Enter the keyword both to indicate that the system sends and accepts multiple
paths from peers.
path-count Enter the number paths supported. The range is from 2 to 64.
Defaults Disabled
Command Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Related Commands neighbor add-path — species that this neighbor/peer group can send/receive multiple path
advertisements.
338
Border Gateway Protocol