Service Manual

To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to debug BGP information
corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol operations corresponding
to either a default or non-default VRF.
A.B.C.D Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
Enter the keywords peer-group then the name of the peer group to debug.
in (OPTIONAL) Enter the keyword in to view only information on inbound BGP
routes.
out (OPTIONAL) Enter the keyword out to view only information on outbound BGP
routes.
A.B.C.D Enter the IP address of peer in the A.B.C.D format.
X:X:X:X::X Enter the IPv6 IP address of peer in the X:X:X:X::X format.
dampening Enter the keyword dampening to view BGP dampening.
events Enter the keyword events to view BGP protocol events.
ipv4 Enter the ipv4 IP address to view the IPV4 route information.
ipv6 Enter the ipv6 IP address to view the IPV6 route information.
keepalives Enter the keyword keepalives to view BGP keepalives.
notications Enter the keyword notifications to view BGP notications.
soft-reconguration Enter the keywords soft-reconfiguration to view only information on
inbound BGP soft reconguration.
updates Enter the keyword updates to view BGP updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol
363