Service Manual
Version Description
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information By default, when you create a neighbor/peer group conguration in the Router BGP context, this enables
IPv4/Unicast AFI/SAFI. When you use activate in the new context, the neighbor/peer group enables for
AFI/SAFI.
It is not possible to de-activate a peer from the IPv4 unicast address family.
neighbor add-path
This command allows the specied neighbor/peer group to send/receive multiple path advertisements.
Syntax
neighbor [ip-address | peer-group-name] add-path [send | receive | both]
path-count
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group.
send Enter the keyword send to indicate that the system sends multiple paths to peers.
receive Enter the keyword receive to indicate that the system accepts multiple paths
from peers.
both Enter the keyword both to indicate that the system sends and accepts multiple
paths from peers.
path-count Enter the number paths supported. The range is from 2 to 64.
Defaults none
Command Modes CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Related Commands bgp add-path — allows the advertisement of multiple paths for the same address prex without the new
paths implicitly replacing any previous ones.
Border Gateway Protocol
373