Service Manual

If you congure a password on one neighbor, but you have not congured a password for the neighboring
router, the following message appears on the console while the routers attempt to establish a BGP session
between them:
%RPM0-P:RP1 %KERN-6-INT: No BGP MD5 from [peer's IP address]
:179 to [local router's IP address]:65524
Also, if you congure dierent passwords on the two routers, the following message appears on the console:
%RPM0-P:RP1 %KERN-6-INT: BGP MD5 password mismatch from
[peer's IP address] : 11502 to [local router's IP address] :179
neighbor peer-group (assigning peers)
Allows you to assign one peer to an existing peer group.
Syntax
neighbor {ip-address | peer-group peer-group-name} dmzlink-bw
To delete a peer from a peer group, use the no neighbor {ip-address | peer-group peer-
group-name} command.
To disable dmzlink-dw for the peer group, use the no neighbor ip-address dmzlink-dw
command.
Parameters
ip-address Enter the IP address of the router to be included in the peer group.
peer-group-name Enter the name of a congured peer group.
dmzlink-bw Enter the keyword dmzlink-bw to attach a link bandwidth to received routes.
NOTE: If dmzlink-bw is congured for a peer, in order for the BGP peer to
advertise the prexes with dmzlink-bw attached to it, you must reset the
the peer or peer-group using the clear ip bgp session command.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Added the dmzlink-bw parameter.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
384
Border Gateway Protocol