Service Manual
In order that settings corresponding to the neighbor send-community command take eect, you
must execute the clear ip bgp command immediately after you execute the neighbor send-
community
command.
If you do not set any of the optional parameters (standard or extended), then both standard as well as
extended attributes are sent. If you set either the standard or extended parameter, only the attribute that is
specied is sent.
neighbor shutdown
Disable a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-
name}no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer
group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
Peers that are enabled within a peer group are disabled when their peer group is disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or BGP peer
group. Use this command with caution as it terminates the specied BGP sessions. When a neighbor or peer
group is shut down, use the show ip bgp summary command to conrm its status.
Related Commands
show ip bgp summary — displays the current BGP conguration.
Border Gateway Protocol
393