Service Manual
neighbor weight
Assign a weight to the neighbor connection, which is used to determine the best path.
Syntax
neighbor {ip-address | peer-group-name} weight weight
To remove a weight value, use the no neighbor {ip-address | peer-group-name} weight
command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to disable all routers within the peer group.
weight Enter a number as the weight. The range is from 0 to 65535. The default is 0.
Defaults 0
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
In the Dell Networking OS best path selection process, the path with the highest weight value is preferred.
NOTE: In the Dell Networking OS best-path selection process, the path with the highest weight
value is preferred.
If you congure the set weight command in a route map applied to this neighbor, the weight set in that
command overrides the weight set in the neighbor weight command.
Related Commands set weight — assigns a weight to all paths meeting the route map criteria.
Border Gateway Protocol
397