Service Manual

network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-name]
command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prex length format (for example, /
24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
398
Border Gateway Protocol