Service Manual

Version Description
6.3.10 The output is changed to display the total number of advertised prexes.
Usage Information
After a peer reset, the contents of the notication log messages is displayed in hex values for debugging.
The neighbor information that this command displays does not include counts corresponding to ignored
prexes and updates. However, the martian case is an exception where neighbor information corresponding
to ignored updates is displayed.
BGP shows the exact information that is exchanged between the BGP peers. It also indicates whether or
not this information is received by the BGP peer.
The following describes the show ip bgp neighbors command shown in the following examples.
The Lines
Beginning with:
Description
BGP neighbor Displays the BGP neighbor address and its AS number. The last phrase in the line
indicates whether the link between the BGP router and its neighbor is an external
or internal one. If they are located in the same AS, the link is internal; otherwise the
link is external.
BGP version Displays the BGP version (always version 4) and the remote router ID.
BGP state Displays the neighbor’s BGP state and the amount of time in
hours:minutes:seconds it has been in that state.
Last read This line displays the following information:
• last read is the time (hours:minutes:seconds) the router read a message from
its neighbor
• hold time is the number of seconds congured between messages from its
neighbor
• keepalive interval is the number of seconds between keepalive messages to
help ensure that the TCP session is still alive.
Received messages This line displays the number of BGP messages received, the number of
notications (error messages), and the number of messages waiting in a queue for
processing.
Sent messages The line displays the number of BGP messages sent, the number of notications
(error messages), and the number of messages waiting in a queue for processing.
Received updates This line displays the number of BGP updates received and sent.
Soft reconguration This line indicates that soft reconguration inbound is congured.
Minimum time Displays the minimum time, in seconds, between advertisements.
(list of inbound and
outbound policies)
Displays the policy commands congured and the names of the Route map, AS-
PATH ACL, or Prex list congured for the policy.
For address family: Displays the IPv4 Unicast as the address family.
BGP table version Displays which version of the primary BGP routing table the router and the
neighbor are using.
accepted prexes Displays the number of network prexes the router accepts and the amount of
memory used to process those prexes.
Border Gateway Protocol
425