Service Manual

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the
ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp peer-group command shown in the following example.
Line beginning
with:
Description
Peer-group Displays the peer group’s name.
Administratively
shut
Displays the peer group’s status if the peer group is not enabled. If you enable the
peer group, this line is not displayed.
BGP version Displays the BGP version supported.
Minimum time Displays the time interval between BGP advertisements.
For address family Displays IPv4 Unicast as the address family.
BGP neighbor Displays the name of the BGP neighbor.
Number of peers Displays the number of peers currently congured for this peer group.
Peer-group
members:
Lists the IP addresses of the peers in the peer group. If the address is outbound
optimized, an * is displayed next to the IP address.
Example
Dell#show ip bgp peer-group
Peer-group port0, remote AS 200
BGP version 4
Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast
BGP neighbor is port0, peer-group external
Update packing has 4_OCTET_AS support enabled
Number of peers in this group 1
Maximum limit on the accepted connections 256
Peer-group members (* - outbound optimized):
172.16.0.2
Dell#
Related Commands
neighbor peer-group (assigning peers) — assigns a peer to a peer-group.
Border Gateway Protocol
431