Service Manual

Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
To determine a BGP session ap, both a route-down event and a subsequent route-up event corresponding
to a single route are considered. As a result, a ap event is penalized only one time during the route-down
event. The subsequent route-up event corresponding to the same route is not considered as a ap and is
not penalized.
The history paths that the show ip bgp command displays contain only the prex and the next-hop
information. The next-hop information shows the ip address of the neighbor. It does not show the actual
next-hop details.
The following describes the show ip bgp damp command shown in the following example.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the dampened route.
Reuse Displays the hour:minutes:seconds until the dampened route is available.
Path Lists all the ASs the dampened route passed through to reach the destination
network.
Example
Dell#show ip bgp dampened-paths
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r -
redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
d 55.0.0.0/24 172.16.0.2 00:36:23 200
Dell#
440
Border Gateway Protocol