Service Manual

neighbor soft-reconguration inbound
Enable a BGP soft-reconguration and start storing updates for inbound IPv6 unicast routes.
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address | ipv6-
address
Enter the IP address of the neighbor for which you want to start storing inbound
routing updates.
peer-group-name Enter the name of the peer group for which you want to start storing inbound
routing updates.
Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address families.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information This command enables soft-reconguration for the specied BGP neighbor. BGP stores all updates for
inbound IPv6 unicast routes the neighbor receives but does not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update
database from the neighbor is stored in memory regardless of the inbound policy results applied on
the neighbor.
show ipv6 prex-list
Displays the specied IPv6 prex list.
Syntax
show ipv6 prefix-list detail {prefix-list name} | summary
Parameters
detail Display a detailed description of the selected IPv6 prex list.
prex-list name Enter the name of the prex list.
NOTE: There is a 140-character limit for prex list names.
Border Gateway Protocol
447