Service Manual
Version Description
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Claried block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-cong (write-mem or copy run start) then reload the
system for the new settings to take eect.
The total amount of space allowed is 16 FP Blocks. System ow requires three blocks; these blocks cannot
be reallocated. Only 13 number of blocks can be congured by the user .
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any conguration changes that have
changed the NVRAM content, use the command reload conditional nvram-cfg-change.
cam-acl-egress
Allocate CAM for egress ACLs.
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl number
Parameters
default Reset egress CAM ACL entries to default settings.
l2acl number Allocate space to each CAM region. The total space allocated must equal 4. The
ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command..
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
452
Content Addressable Memory (CAM)