Manualshelf

Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON
491492493494495496497498499500
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.
default-router
Assign a default gateway to clients based on the address pool.
Syntax
default-router address [address2...address8]
Parameters
address Enter a list of routers that may be the default gateway for clients on the subnet.
You may specify up to eight routers. List them in order of preference.
Defaults none
Command Modes DHCP <POOL>
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
disable
Disable the DHCP server.
Syntax
disable
DHCP Server is disabled by default. To enable the system to be a DHCP server, use the no disable
command.
Defaults Disabled
Dynamic Host Conguration Protocol (DHCP)
495