Service Manual
redundancy auto-failover-limit
Specify an auto-failover limit for RPMs. When a non-recoverable fatal error is detected, an automatic RPM failover occurs. This
command does not aect user-initiated (manual) failovers.
Syntax
redundancy auto-failover-limit [count number [period minutes] | period
minutes]]
To disable the auto-failover limit control, use the no redundancy auto-failover-limit command.
Parameters
count number Enter the number of times the RPMs can automatically failover within the period
dened in the period parameter. The range is from 2 to 10. The default is 3.
period minutes Enter a duration in which to allow a number of automatic failovers (limited to the
number dened in the count parameter). The range is from 5 to 9000 minutes. The
default is 60 minutes.
Default
• Count: 3
• Period: 60 minutes
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series
Usage Information
If you disable auto failover, enter the redundancy auto-failover-limit (without any parameters)
to set auto failover to the default parameters (Count 3, Period 60 minutes). To view the redundancy status,
use the show redundancy command.
When you change one or both of the optional parameters, Dell Networking OS checks that the interval
between auto failovers is more than ve (5) minutes. If the interval is less, Dell Networking OS returns a
conguration error message.
High Availability (HA)
565