Service Manual
• For a port channel interface, enter the keywords port-channel then a
number.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This
command displays packets for IGMP and IGMP snooping.
ip igmp access-group
To specify access control for packets, use this feature.
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list command.
Parameters
access-list Enter the name of the extended ACL (16 characters maximum).
Defaults Not congured
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
Internet Group Management Protocol (IGMP)
579