Service Manual
Version Description
9.7(0.0) Changed the default IGMP from version 2 to version 3. Introduced on the S6000-
ON
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
show ip igmp groups
View the IGMP groups.
Syntax
show ip igmp [vrf vrf-name] groups [group-address [detail] | detail |
interface [group-address [detail]]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to
congure this setting on that VRF.
group-address (OPTIONAL) Enter the group address in dotted decimal format to view information
on that group only.
interface (OPTIONAL) Enter the interface type and slot/port information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a port channel interface, enter the keywords port-channel then a
number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
detail (OPTIONAL) Enter the keyword detail to display the IGMPv3 source
information.
Command Modes
• EXEC
• EXEC Privilege
Internet Group Management Protocol (IGMP)
585