Service Manual
show running-cong ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven trac distribution using the ecmp-group monitoring
enable command. The ECMP group could have a LAG or a list of 10G/40 interfaces (not just LAG link-bundles).
Syntax
show running-config ecmp-group
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Related Commands ecmp-group — congures a mechanism to monitor trac distribution.
shutdown
Disable an interface.
Syntax
shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Interfaces
649