Service Manual
Command Modes EIS Mode (conf-mgmt-eis)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
application (for HTTP and ICMP)
Congure the management egress interface selection for HTTP and ICMP.
NOTE: Only the options that have been newly introduced are described here. For a complete description on all of the
keywords and variables that are available with this command, refer the respective Command Reference Guide of the
applicable platform of the Release 9.2(0.0) documentation set.
Syntax
application {all | application-type}
To remove a management application conguration, use the no application {all |
application-type} command.
Parameters
application-type Enter any of the following keywords:
• For HTTP, enter the keyword http.
• For ICMP, enter the keyword icmp.
all Congure all applications.
Defaults None.
Command Modes EIS Mode (conf-mgmt-eis)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.3.(0.0) Added support for the HTTP and ICMP trac on the Z9000, S4810, and S4820T.
clear management application pkt-cntr
Clear management application packet counters for all management application types.
Syntax
clear management application pkt-cntr
Interfaces
655