Service Manual
Usage Information If the TDR test has not been run, an error message is generated:
%Error: Please run the TDR test first
The following describes the TDR test status.
Status Denition
OK Status:
Terminated
TDR test is complete, no fault is detected on the cable, and the test is terminated.
Length: 92 (+/- 1)
meters, Status:
Shorted
A short is detected on the cable. The location, in this Example is 92 meters. The
short is accurate to plus or minus one meter.
Length: 93 (+/- 1)
meters, Status:
Open
An opening is detected on the cable. The location, in this Example is 93 meters.
The open is accurate to plus or minus one meter.
Status: Impedance
Mismatch
There is an impedance mismatch in the cables.
Example
Dell#show tdr gigabitethernet 10/47
Time since last test: 00:00:02
Pair A, Length: OK Status: Terminated
Pair B, Length: 92 (+/- 1) meters, Status: Short
Pair C, Length: 93 (+/- 1) meters, Status: Open
Pair D, Length: 0 (+/- 1) meters, Status: Impedance Mismatch
Related Commands tdr-cable-test — runs the TDR test.
UDP Broadcast
The user datagram protocol (UDP) broadcast feature is a software-based method to forward low throughput (not to exceed 200
pps) IP/UDP broadcast trac arriving on a physical or VLAN interface.
Important Points to Remember
• This feature is available only on the platform.
• Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
• If you congure this feature on an interface using the ip udp-helper udp-port command, the ip directed-
broadcast command becomes ineective on that interface.
• The existing show interface command has been modied to display the congured broadcast address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Interfaces
671