Service Manual

If you only congure the ip udp-helper udp-port command, all the UDP broadcast trac is ooded,
including ports 67/68 trac if those ports are part of the udp-port-list.
Related Commands
ip helper-address — congures the destination broadcast or host address for the DHCP server.
debug ip udp-helper — enables debug and displays the debug information on a console.
show ip udp-helper — displays the congured UDP helpers on all interfaces.
show ip udp-helper
Display the congured UDP helpers on all interfaces.
Syntax
show ip udp-helper
Defaults none
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Pre-version 8.3.7.0 Introduced on the E-Series ExaScale.
Example
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
Gi 10/2 656, 658
Gi 10/3 All
Related Commands
debug ip udp-helper — enables debug and displays the debug information on a console.
ip udp-broadcast-address — congures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface either for all UDP ports or a
specied list of UDP ports.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
This feature is supported on platform.
674
Interfaces