Service Manual
25
IPv4 Routing
The basic IPv4 commands are supported by Dell Networking operating system on the platform.
arp
To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).
Syntax
arp [vrf vrf-name] ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
vrf vrf-name Enter a VRF name to congure an ARP entry for that VRF. Use the VRF option
after the keyword arp to congure a static arp on that particular VRF.
ip-address Enter an IP address in dotted decimal format.
mac-address Enter a MAC address in nnnn.nnnn.nnnn format.
interface (OPTIONAL) Enter any of the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information. The slot range is from
1 to 11. The port range is 1.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
IPv4 Routing
685