Service Manual
tengigabitethernet Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet interfaces.
Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prex are not reected in the hardware routing tables. Separate routing tables are
maintained for IPv4 and IPv6 management routes. This command manages both tables.
Related Commands
interface ManagementEthernet — congures the Management port on the system (either the Primary or
Standby RPM).
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table.
Syntax
show arp [vrf vrf-name] [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [retries] [static | dynamic]
[inspection {database | statistics][summary]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF.
IPv4 Routing
723