Service Manual

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information. The slot range is from
1 to 11. The port range is 1.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a stack-unit interface, enter the keyword stack-unit then the stack unit
number.
• For a tunnel interface, enter the keyword tunnel then the tunnel interface
number. The range is from 1 to 16383.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces
and whether an IP address is assigned.
congured (OPTIONAL) Enter the keyword configured to display the physical interfaces
with non-default congurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip interface command shown in the following example.
734
IPv4 Routing