Service Manual
R 2.1.3.0/24 via 2.1.4.1, Gi 4/43 120/1 3d1h
C 2.1.4.0/24 Direct, Gi 4/43 0/0 3d1h
Related Commands
ip prex-list — enters CONFIGURATION-IP PREFIX-LIST mode and congures a prex list.
show ip prex-list summary — displays a summary of the congured prex lists.
show ip route summary
View a table summarizing the IP routes in the switch.
Syntax
show ip route vrf vrf-name summary
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip route summary shown in the following example.
Column Heading Description
Route Source Identies how the route is congured in Dell Networking OS.
Active Routes Identies the best route if a route is learned from two protocol sources.
Non-active Routes Identies the back-up routes when a route is learned by two dierent protocols. If
the best route or active route goes down, the non-active route becomes the best
route.
744
IPv4 Routing