Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
8.4.2.0 Introduced on the E-Series TeraScale.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
For the new settings to take eect, save the new CAM settings to the startup-cong (write-mem or
copy run start), then reload the system.
The total amount of space allowed is 4 FP Blocks.
Example
Dell#
Dell#configure
Dell(conf)#cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
Dell(conf)#cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
Dell(conf)#cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4> Number of FP blocks for IPV6 (multiples of 2)
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
cam-acl
Allocate space for IPv6 ACLs.
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos
1-10}
Parameters
default Use the default CAM prole settings, and set the CAM as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
l2acl 1-10 ipv4acl
1-10 ipv6acl 0-10
ipv4qos 1-10 l2qos
1-10
Allocate space to support IPv6 ACLs. Enter all of the proles and a range. Enter the
CAM prole name then the amount to be allotted. The total space allocated must
equal 13. The ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
IPv6 Access Control Lists (IPv6 ACLs)
757