Service Manual

clear ipv6 route

Clear (refresh) all or a specic route from the IPv6 routing table.

Syntax

clear ipv6 route [vrf vrf-name] {* | ipv6-address prefix-length}

Parameters

vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to clear the

IPv6 routes corresponding to that VRF.

* Enter the * to clear (refresh) all routes from the IPv6 routing table.

ipv6-address prex-

length

Enter the IPv6 address in the x:x:x:x::x format then the prex length in the /x

format. The range is from /0 to /128.

NOTE: The :: notation species successive hexadecimal elds of zeros.

Command Modes EXEC Privilege

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.2.1.0 Introduced on the E-Series ExaScale.

7.8.1.0 Introduced on the C-Series and S-Series.

7.4.1.0 Introduced on the E-Series TeraScale.

clear ipv6 mld_host

Clear the IPv6 MLD host counters and reset the elapsed time.