Service Manual

show ipv6 owlabel-zero
Display the ow label zero setting.
Syntax
show ipv6 flowlabel-zero
Default Disabled
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related Commands ipv6 nd dad attempts — Congure system to set the ow label eld in the packets to zero.
show ipv6 interface
Display the status of interfaces congured for IPv6.
Syntax
show ipv6 interface interface [brief] [configured] [gigabitethernet slot |
slot/port] [loopback interface-number] [managementethernet slot/port]
[port-channel number] [stack-unit id] [tengigabitethernet slot | slot/port]
[tunnel tunnel-id] [vlan vlan-id]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a port channel interface, enter the keywords port-channel then a
number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For stacking, enter the keywords stack-unit then the stack-unit ID.
• For a tunnel interface, enter the keyword tunnel then the tunnel ID.
776
IPv6 Basics