Service Manual

brief (OPTIONAL) View a summary of IPv6 interfaces.
congured (OPTIONAL) View information on all IPv6 congured interfaces.
gigabitethernet (OPTIONAL) View information for an IPv6 gigabitethernet interface.
managementethern
et slot/ port
(OPTIONAL) View information on an IPv6 Management port. Enter the slot
number (0-1) and port number zero (0).
loopback (OPTIONAL) View information for IPv6 Loopback interfaces.
port-channel (OPTIONAL) View information for IPv6 port channels.
tengigabitethernet (OPTIONAL) View information for an IPv6 tengigabitethernet interface.
stack-unit id (OPTIONAL) View information for stacking.
tunnel tunnel-id (OPTIONAL) View information for a tunnel interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2.(0.0) Added support for tunnel interface.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
7.8.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information The Management port is enabled by default (no shutdown). If necessary, use the ipv6 address
command to assign an IPv6 address to the Management port.
Example
Dell#show ipv6 interface gigabit 1/12
GigabitEthernet 1/12 is up, line protocol is up
IPV6 is enabled
Link Local address: fe80::201:e8ff:fea7:497e
Global Unicast address(es):
100::2, subnet is 100::/64 (MANUAL)
Remaining lifetime: infinite
Global Anycast address(es):
IPv6 Basics
777