Service Manual

debug isis update-packets
Enable debugging on link state PDUs (LSPs) that a router detects.
Syntax
debug isis [vrf vrf-name] update-packets [interface]
To turn o debugging, use the no debug isis update-packets [interface] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable the
debugging information on IS-IS. This information contains updates from neighbors
tied to the VRF that you specify. This command displays the debugging details of
the received LSPs from the neighbors.
interface (OPTIONAL) Identies the interface type slot/port as one of the following:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(0.2) Introduced on the Z9000.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
6.3.1.0 Introduced.
default-information originate
Generates a default route into an IS-IS routing domain and controls the distribution of default information.
Syntax
default-information originate [always] [metric metric] [route-map map-name]
To disable the generation of a default route into the specied IS-IS routing domain, use the no default-
information originate [always] [metric metric] [route-map map-name] command.
Intermediate System to Intermediate System (IS-IS)
793