Service Manual

Version Description
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information This command allows you to monitor adjacency state changes, which are useful when you monitor large
networks. Messages are logged in the system’s error message facility.
lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l | level-2] interval
seconds [initial_wait_interval seconds [second_wait_interval seconds]]
command.
Parameters
level-l (OPTIONAL) Enter the keywords level-1 to apply the conguration to
generation of Level-1 LSPs.
level-2 (OPTIONAL) Enter the keywords level-2 to apply the conguration to
generation of Level-2 LSPs.
interval seconds Enter the maximum number of seconds between LSP generations. The range is
from 0 to 120 seconds. The default is 5 seconds.
initial_wait_interval
seconds
(OPTIONAL) Enter the initial wait time, in seconds, before running the rst LSP
generation. The range is from 0 to 120 seconds. The default is 1 second.
second_wait_interv
al seconds
(OPTIONAL) Enter the wait interval, in seconds, between the rst and second LSP
generation. The range is from 0 to 120 seconds. The default is 5 seconds.
Defaults Refer to Parameters.
Command Modes ROUTER ISIS
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
818
Intermediate System to Intermediate System (IS-IS)