Service Manual
max-area-addresses
Congure manual area addresses.
Syntax
max-area-addresses number
To return to the default values, use the no max-area-addresses command.
Parameters
number Set the maximum number of manual area addresses. The range is from 3 to 6. The
default is 3.
Defaults 3 addresses
Command Modes ROUTER ISIS
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Added support for LSP Throttling Enhancement.
Usage Information To congure the number of area addresses on router, use this command. This value must be consistent with
routers in the same area, otherwise the router forms only Level 2 adjacencies. The value must be same
among all the routers to form Level 1 adjacencies.
max-lsp-lifetime
Set the maximum time that link-state packets (LSPs) exist without being refreshed.
Syntax
max-lsp-lifetime seconds
To restore the default time, use the no max-lsp-lifetime command.
Parameters
seconds The maximum lifetime of LSP in seconds. This value must be greater than the
lsp-refresh-interval command. The higher the value the longer the LSPs
are kept. The range is from 1 to 65535. The default is 1200.
Defaults 1200 seconds
Command Modes ROUTER ISIS
Intermediate System to Intermediate System (IS-IS)
821