Service Manual

net
To congure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If you did not congure a NET,
the IS-IS process does not start.
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-title Specify the area address and system ID for an IS-IS routing process. The rst 1 to
13 bytes identify the area address. The next 6 bytes identify the system ID. The last
1 byte is the selector byte, always identied as zero zero (00). This argument can
be applied to an address or a name.
Defaults Not congured.
Command Modes ROUTER ISIS
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that interface.
Syntax
passive-interface interface
To delete a passive interface conguration, use the no passive-interface interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Intermediate System to Intermediate System (IS-IS)
825