Service Manual

level-1-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 2 routes.
This setting is the default.
route-map map-
name
(OPTIONAL) If you do not enter the route-map argument, all routes are
redistributed. If a map-name value is not specied, no routes are imported.
Defaults
• metric metric-value = 0
• metric-type= internal; level-2
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added support for IPv6 ISIS.
6.3.1.0 Introduced.
Usage Information
To redistribute a default route (0.0.0.0/0), congure the default-information originate
command.
Changing or disabling a keyword in this command does not aect the state of the other command
keywords.
When an LSP with an internal metric is received, the Dell Networking OS considers the route cost while
considering the advertised cost to reach the destination.
Redistributed routing information is ltered with the distribute-list out command to ensure that
the routes are properly passed to the receiving routing protocol.
How a metric value assigned to a redistributed route is advertised depends on how on the conguration of
the metric-style command. If the metric-style command is set for Narrow or Transition mode and
the metric value in the redistribute command is set to a number higher than 63, the metric value
advertised in LSPs is 63. If the
metric-style command is set for Wide mode, the metric value in the
redistribute command is advertised.
Related Commands
• default-information originate — generates a default route for the IS-IS domain.
Intermediate System to Intermediate System (IS-IS)
827