Service Manual
level-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 2 routes.
This setting is the default.
match {external |
internal}
(OPTIONAL) The command used for OSPF to route and redistribute into other
routing domains. The values are
• internal
• external
route-map map-
name
map-name is an identier for a congured route map. The route map should lter
imported routes from the source routing protocol to the current routing protocol.
If you do not specify a map-name, all routes are redistributed. If you specify a
keyword, but fail to list route map tags, no routes are imported.
Defaults Refer to Parameters.
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added support for IPv6 ISIS.
6.3.1.0 Introduced.
Usage Information How a metric value assigned to a redistributed route is advertised depends on how on the conguration of
the metric-style command. If the metric-style command is set for Narrow mode and the metric
value in the redistribute ospf command is set to a number higher than 63, the metric value
advertised in LSPs is 63. If the
metric-style command is set for wide mode, the metric value in the
redistribute ospf command is advertised.
830
Intermediate System to Intermediate System (IS-IS)