Service Manual

show fefd
View FEFD status globally or on a specic interface.
Syntax
show fefd [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
Legacy E-Series
command.
Usage Information The following describes the show fefd command shown in the following example.
Field Description
Interface Displays the interfaces type and number.
Mode Displays the mode (aggressive or normal) or NA if the interface contains fefd
reset in its conguration.
Interval Displays the interval between FEFD packets.
State Displays the state of the interface and can be one of the following:
• bi-directional (interface is up, connected and hearing neighbor’s echoes).
• err-disabled (only found when FEFD mode is aggressive and when the interface
has not hearing its neighbor’s echoes for three times the message interval. To
reset an interface in this state, use the fefd reset command.)
• unknown (only found when FEFD mode is normal.
886
Layer 2