Service Manual

management-interface
Enable and congure LLDP protocol parameters on the management interface.
Syntax
management-interface
To remove LLDP conguration on a management interface, use the no management-interface
command.
Command Modes LLDP (conf-lldp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(0.2) Introduced on the Z9000 and S4810.
Usage Information
To enable LLDP on the management interface, use the no disable command in LLDP-MANAGEMENT-
INTERFACE mode (conf-lldp-mgmtIf).
mode
To receive or transmit, set LLDP.
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Defaults Both transmit and receive.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
896
Link Layer Discovery Protocol (LLDP)