Service Manual

To return to the default, use the no advertise med voice {vlan-id layer2_priority
DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority (C-Series and E-Series only). The range is from 0 to 7.
DSCP_value Enter the DSCP value (C-Series and E-Series only). The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged then the Layer 2 priority. The range is
from 0 to 7.
Defaults uncongured.
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series and E-Series.
Related Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
advertise med voice-signaling
To advertise when voice control packets use a separate network policy than voice data, congure the system.
Syntax
advertise med voice-signaling {vlan-id layer2_priority DSCP_value} |
{priority-tagged number}
To return to the default, use the no advertise med voice-signaling {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority (C-Series and E-Series only). The range is from 0 to 7.
DSCP_value Enter the DSCP value (C-Series and E-Series only). The range is from 0 to 63.
910
Link Layer Discovery Protocol (LLDP)