Service Manual
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced
Usage Information
Modications to the ACL do not have an immediate eect on the sa-cache.
To apply the redistribute lter to entries already present in the SA cache, use the clear ip msdp sa-
cache local command.
ip msdp sa-lter
Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the specied peer.
Syntax
ip msdp sa-filter {in | out} peer-address list [access-list name]
Remove this conguration using the no ip msdp sa-filter {in | out} peer address list
[access-list name] command.
Parameters
in Enter the keyword in to enable incoming SA ltering.
out Enter the keyword out to enable outgoing SA ltering.
peer-address Enter the peer address of the MSDP peer in a dotted decimal format (A.B.C.D.).
access-list name Enter the name of an extended ACL that contains permitted SAs. If you do not use
this option, all local entries are blocked.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
Multicast Source Discovery Protocol (MSDP)
923