Service Manual
exec-timeout
Set a time interval that the system waits for input on a line before disconnecting the session.
Syntax
exec-timeout minutes [seconds]
To return to default settings, use the no exec-timeout command.
Parameters
minutes Enter the number of minutes of inactivity on the system before disconnecting the
current session. The range is from 0 to 35791. The default is 10 minutes for the
console line and 30 minutes for the VTY line.
seconds (OPTIONAL) Enter the number of seconds. The range is from 0 to 2147483. The
default is 0 seconds.
Defaults 10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command Modes LINE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information To remove the time interval, enter exec-timeout 0 0.
Example
Dell con0 is now available
Press RETURN to get started.
Dell>
exit
Return to the lower command mode.
Syntax
exit
Command Modes
• EXEC Privilege
• CONFIGURATION
94
Control and Monitoring