Service Manual
tc-ush-standard
Enable the MAC address ushing after receiving every topology change notication.
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced
Usage Information By default, Dell Networking OS implements an optimized ush mechanism for MSTP. This mechanism helps
in ushing the MAC addresses only when necessary (and less often) allowing for faster convergence during
topology changes. However, if a standards-based ush mechanism is needed, this knob command can be
turned on to enable ushing MAC addresses after receiving every topology change notication.
Multiple Spanning Tree Protocol (MSTP)
943