Service Manual

Version Description
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Example
Dell#debug track all
04:35:04: %RPM0-P:RP2 %OTM-5-STATE: track 6 - Interface GigabitEthernet 1/2
line-protocol DOWN
04:35:04: %RPM0-P:RP2 %OTM-5-NOTIF: VRRP notification: resource ID 6 DOWN
delay
Congure the time delay used before communicating a change in the status of a tracked object to clients.
Syntax
delay {[up seconds] [down seconds]}
To return to the default setting, use the no delay command.
Parameters
seconds Enter the number of seconds the object tracker waits before sending a notication
about the change in the UP and/or DOWN state of a tracked object to clients. The
range is 0 to 180. The default is 0 seconds.
Defaults 0 seconds
Command Modes OBJECT TRACKING (conf_track_object-id)
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information
You can congure an UP and/or DOWN timer for each tracked object to set the time delay before a change
in the state of a tracked object is communicated to clients. The congured time delay starts when the state
changes from UP to DOWN or vice-versa.
If the state of an object changes back to its former UP/DOWN state before the timer expires, the timer is
cancelled and the client is not notied. For example, if the DOWN timer is running when an interface goes
down and comes back up, the DOWN timer is cancelled and the client is not notied of the event.
If the timer expires and an object’s state has changed, a notication is sent to the client. If no delay is
congured, a notication is sent immediately after a change in the state of a tracked object is detected. The
time delay in communicating a state change is specied in seconds.
Related Commands
• track interface ip routing – congures object tracking on the routing status of an IPv4 Layer 3 interface.
• track interface line-protocol – congures object tracking on the line-protocol state of a Layer 2 interface.
• track ip route metric threshold – congures object tracking on the threshold of an IPv4 route metric.
• track ip route reachability – congures object tracking on the reachability of an IPv4 route.
968
Object Tracking