Service Manual

Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information The hostname is used in the prompt.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
This feature is supported on platform.
Syntax ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a port channel interface, enter the keywords port-channel then a
number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S4810, S4820T, S6000, and Z9000.
8.3.11.1 Introduced on the Z9000
8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
8.1.1.0 Introduced on E-Series ExaScale
7.6.1.0 Support added for S-Series
7.5.1.0 Introduced on C-Series
Related Commands
ip ftp source interface
Control and Monitoring
99