Service Manual

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
neighbor router-id (OPTIONAL) Enter the keyword neighbor then the neighbor’s router-id in dotted
decimal format (A.B.C.D.).
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Related Commands show ip ospf statistics — displays the OSPF statistics.
debug ip ospf
Display debug information on OSPF. Entering the debug ip ospf commands enables OSPF debugging for the rst OSPF
process.
S3048–ON
Syntax
debug ip ospf [process-id] [vrf vrf-name] [bfd |event | packet | spf |
database-timer rate-limit]
To cancel the debug command, use the no debug ip ospf command.
Parameters
process-id Enter the OSPF Process ID to clear a specic process. If no Process ID is entered,
all OSPF processes are cleared.
bfd (OPTIONAL) Enter the keyword bfd to debug only OSPF BFD information.
event (OPTIONAL) Enter the keyword event to debug only OSPF event information.
packet (OPTIONAL) Enter the keyword packet to debug only OSPF packet information.
spf (OPTIONAL) Enter the keyword spf to display the Shortest Path First information.
Open Shortest Path First (OSPFv2 and OSPFv3)
991