Setup Guide

– The Header that gets attached to the packet is 38 bytes long. In case of a packet with L3 VLAN, it would be 42 bytes long.
The original payload /original mirrored data starts from the 39
th
byte in a given ERPM packet. The rst 38/42 bytes of the
header needs to be ignored/ chopped o.
– Some tools support options to edit the capture le. We can make use of such features (for example: editcap ) and chop the
ERPM header part and save it to a new trace le. This new le (i.e. the original mirrored packet) can be converted back into
stream and fed to any egress interface.
b Using Python script
– Either have a Linux server's ethernet port ip as the ERPM destination ip or connect the ingress interface of the server to the
ERPM MirrorToPort. The analyzer should listen in the forward/egress interface. If there is only one interface, one can choose
the ingress and forward interface to be same and listen in the tx direction of the interface.
– Download/ Write a small script (for example: erpm.py) such that it will strip the given ERPM packet starting from the bit
where GRE header ends. Basically all the bits after 0x88BE need to be removed from the packet and sent out through another
interface.
– This script erpm.zip is available for download at the following location: https://en.community.dell.com/techcenter/
networking/m/force10_networking_scripts/20438882.aspx
– Unzip the erpm.zip and copy the erpm.py le to the Linux server.
– Run the python script using the following command:
python erpm.py -i <ingress interface> -o <egress interface>
erpm.py : This is the script downloaded from the script store.
<Ingress interface> : Specify the interface id which is connected to the mirroring port or this should be interface whose ip address has
been specied as the destination ip address in the ERPM session.
<Egress interface> : Specify another interface on the Linux server via which the decapsulation packets can Egress. In case there is only
one interface, the ingress interface itself can be specied as Egress and the analyzer can listen in the tx direction.
Port Monitoring on VLT
Devices on which VLT is congured are seen as a single device in the network. You can apply port monitoring function on the VLT devices
in the network.
Port monitoring enables ingress or egress trac traversing on a port to be sent to another port so that the trac can be analyzed. The
port to which trac is sent for analysis is called the mirroring port. This port is connect to a port analyzer, which performs the trac
analysis function.
Depending up on the location of the port to which the port analyzer is connected, port monitoring is classied into three categories: local
Port mirroring, remote port mirroring (RPM), and encapsulated remote port mirroring (ERPM).
In VLT RPM, Dell EMC Networking OS supports only 3 Mirror-to-Port (MTPs) in hardware.
By default, 2 MTPs are used for ICL lag in VLT. The remaining one MTP is used to mirror only in one direction, either rx or tx.
NOTE
: For more information on port monitoring, see Port Monitoring.
The port monitoring or mirroring function when applied to VLT devices works as expected except with some restrictions. You can congure
RPM or ERPM monitoring between two VLT peers. As VLT devices are seen as a single device in the network, when a fail over occurs, the
source or destination port on one of the VLT peers becomes inactive causing the monitoring session to fail. As a result, Dell EMC
Networking OS does not allow local Port mirroring based monitoring to be congured between VLT peers. However, you can create local
Port mirroring monitoring sessions separately on individual devices that are a part of the VLT conguration.
NOTE
: For more information on conguring VLT, see Conguring VLT.
668 Port Monitoring