Setup Guide
To enable security for SNMP packets transferred between the server and the client, you can use the snmp-server user username
group groupname 3 auth authentication-type auth-password priv aes128 priv-password command to specify
that AES-CFB 128 encryption algorithm needs to be used.
DellEMC(conf)#snmp-server user snmpguy snmpmon 3 auth sha AArt61wq priv aes128 jntRR59a
In this example, for a specied user and a group, the AES128-CFB algorithm, the authentication password to enable the server to receive
packets from the host, and the privacy password to encode the message contents are congured.
SHA authentication needs to be used with the AES-CFB128 privacy algorithm only when FIPS is enabled because SHA is then the only
available authentication level. If FIPS is disabled, you can use MD5 authentication in addition to SHA authentication with the AES-CFB128
privacy algorithm
You cannot modify the FIPS mode if SNMPv3 users are already congured and present in the system. An error message is displayed if you
attempt to change the FIPS mode by using the fips mode enable command in Global Conguration mode. You can enable or disable
FIPS mode only if SNMPv3 users are not previously set up. If previously congured users exist on the system, you must delete the existing
users before you change the FIPS mode.
Keep the following points in mind when you congure the AES128-CFB algorithm for SNMPv3:
1 SNMPv3 authentication provides only the sha option when the FIPS mode is enabled.
2 SNMPv3 privacy provides only the aes128 privacy option when the FIPS mode is enabled.
3 If you attempt to enable or disable FIPS mode and if any SNMPv3 users are previously congured, an error message is displayed
stating you must delete all of the SNMP users before changing the FIPS mode.
4 A message is logged indicating whether FIPS mode is enabled for SNMPv3. This message is generated only when the rst SNMPv3
user is congured because you can modify the FIPS mode only when users are not previously congured. This log message is
provided to assist your system security auditing procedures.
Conguration Task List for SNMP
Conguring SNMP version 1 or version 2 requires a single step.
NOTE
: The congurations in this chapter use a UNIX environment with net-snmp version 5.4. This environment is only one of
many RFC-compliant SNMP utilities you can use to manage your Dell EMC Networking system using SNMP. Also, these
congurations use SNMP version 2c.
• Creating a Community
Conguring SNMP version 3 requires conguring SNMP users in one of three methods. Refer to Setting Up User-Based Security
(SNMPv3).
Related Conguration Tasks
• Managing Overload on Startup
• Reading Managed Object Values
• Writing Managed Object Values
• Subscribing to Managed Object Value Updates using SNMP
• Copying Conguration Files via SNMP
• Manage VLANs Using SNMP
• Enabling and Disabling a Port using SNMP
• Fetch Dynamic MAC Entries using SNMP
• Deriving Interface Indices
• Monitor Port-channels
Simple Network Management Protocol (SNMP)
847