Users Guide
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
OSPFv3 Commands
Open shortest path rst version 3 (OSPFv3) for IPv6 is supported on the S3048–ON platform.
The fundamental mechanisms of OSPF (ooding, DR election, area support, SPF calculations, and so on) remain unchanged. However,
OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most changes were necessary to handle the increased address size of
IPv6.
The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.
area authentication
Congure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.
Syntax
area area-id authentication ipsec spi number {MD5 | SHA1} [key-encryption-type]
key
Parameters
area area-id
Area for which OSPFv3 trac is to be authenticated. For area-id, you can enter a number.
The range is from 0 to 4294967295.
ipsec spi number
Security Policy index (SPI) value that identies an IPsec security policy.
The range is from 256 to 4294967295.
MD5 | SHA1
Authentication type: Message Digest 5 (MD5) or Secure Hash Algorithm 1 (SHA-1).
key-encryption-
type
(OPTIONAL) Species if the key is encrypted.
The values are 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
1074 Open Shortest Path First (OSPFv2 and OSPFv3)