Users Guide
Policy-based Routing (PBR)
Policy-based routing (PBR) allows you to apply routing policies to specic interfaces. To enable PBR, create a redirect list and apply it to the
interface. After the redirect list is applied to the interface, all trac passing through the interface is subject to the rules dened in the
redirect list. PBR is supported by the Dell Networking OS.
You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or virtual local area network
[VLAN]). Trace lists and redirect lists do not function correctly when you congure both in the same conguration.
NOTE: Apply PBR to Layer 3 interfaces only.
NOTE: For more information , see Content Addressable Memory (CAM).
Topics:
• description
• ip redirect-group
• ip redirect-list
• permit
• redirect
• seq
• show cam pbr
• show ip redirect-list
description
Add a description to this redirect list.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the IP redirect list (16 characters maximum).
Defaults None
Command Modes REDIRECT-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
37
Policy-based Routing (PBR) 1107